17. Install the bolts that hold the pump to the oil supply flange. See Figure 4-290. Tighten the bolts to 25 Nm (18.4 ft lb). 18. Use a plastic hammer to lightly tap the pump drive shaft a few times to release tension. See Figure 4-291. FIGURE 4-300 4738 22. Install the 2 roll pins. See Figure 4-294. Install 3 socket head screws to temporarily hold the oil supply flange. FIGURE 4-298 4736 19. Apply Loctite to the flange around the pres- sure intake pathway. A seal ring in good con- FIGURE 4-301 4739 23. Set the adapter case into place on top of the oil supply flange. See Figure 4-295. Install the bolts into the adapter case and tighten to 69 Nm (51 ft lb).
FIGURE 4-299 4737 dition is necessary for the pressure intake pathway. Install 2 assembly studs into the transmission to guide the installation of the oil supply flange and pump assembly. 20. Heat the housing bore that the oil supply flange will be installed into. See Figure 4-292. 21. Install the gasket on the bore of the oil supply flange. Set the oil supply flange and pump assembly into the bore in the transmission. See Figure 4-293. 4-74 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual