FIGURE 4-302 4740 FIGURE 4-304 4742 24. Use a bearing driver to install the bearing into the bearing cover. See Figure 4-296. The top edge of the bearing must be flush with the top edge of the bearing cover. Apply seal ring Type A Torque Converter Assembly FIGURE 4-305 4743 FIGURE 4-303 4741 (Torque Converter Type A is assembled separately from the engine. See Figure 4-70.) compound to the shaft seal and install the seal in the bearing cover. 1. Install the ball bearing (RS) into the torque 25. Thread 2 assembly studs into the adapter case. See Figure 4-297. Install the bearing cover gasket over the studs. Install the bolts to hold the bearing cover in place.
Tighten the bolts to 25 Nm (18.4 ft lb). FIGURE 4-306 4744 converter cover. See Figure 4-298. Install the snap ring to hold the bearing in place. 2. Install the square ring in the top groove of the torque converter shaft. See Figure 4-299. Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-75