daewoo — Daewoo Wheel Loader Shop Manual

3. Coat the O-ring with grease. Install the 4. Set the drive plate on the input shaft. See Figure 4-301. Set the drive collar on top of the drive plate. Coat the bolt threads with Loctite. Install the bolts and tighten to 69 Nm (51 ft lb). Selecting the Spacer Washer NOTE The following steps describe taking measurements and using the measurements to calculate a shim thickness. The measurements shown in these steps are an example only. Be sure to take your own measurements on the transmission you are FIGURE 4-307 4745 O-ring in the groove in the shaft plug. See Figure 4-300. Install the shaft plug. Install the snap ring to hold the shaft plug in place.

FIGURE 4-310 4748 working on, and perform your own calculation to derive the correct shim thickness for your torque converter. 1. Slip the spacer ring over the torque converter FIGURE 4-308 4746 FIGURE 4-311 4749 input shaft. Measure the distance from the flat face of the flange to the top of the spacer ring. See Figure 4-302. In this example this distance measured 5.10 mm. This is measurement A. FIGURE 4-309 4747 4-76 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual