5.10 mm (.200") measurement A -4.60 mm (.181") measurement B .50 mm Figure 4-304. Set the drive plate assembly on top of the diaphragm. Choose a shim washer that exceeds .50 mm Apply Loctite to the 4 bolts. Install and tighten the 4 bolts and washers that hold the drive plate to the torque converter. FIGURE 4-318 4756 by .10 – .30 mm. A shim of .60 mm thickness will create a gap of .10 mm. FIGURE 4-321 4759 .60 mm – .50 mm = .10 mm. FIGURE 4-319 4757 4. Install the shim washer of the thickness that was calculated in the previous step. See FIGURE 4-322 4760 FIGURE 4-320 4758 4-78 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual