7. Install the bolt lock over the 2 bolts that retain the disc. See Figure 4-307. 8. Lift up the torque converter and cover assembly and set it on the bell housing. See FIGURE 4-323 4761 5. Set the cover assembly on the torque con- verter. See Figure 4-305. 6. Slide the drive flange over the input shaft. See FIGURE 4-326 4764 Figure 4-308. Install the bolts through the cover and tighten the nuts to 49 Nm (36 ft lb). FIGURE 4-324 4762 Figure 4-306. Install the disc inside the drive flange. Install 2 bolts into the disc and tighten FIGURE 4-327 4765 Type B Torque Converter Assembly 1. Slip the spacer ring over the torque converter FIGURE 4-325 4763 them to 36 Nm (27 ft lb).
FIGURE 4-328 4766 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-79