daewoo — Daewoo Wheel Loader Shop Manual

shaft. See Figure 4-309. Measure from the flat 2. Take the shim washer that was selected in the previous step, and place it on top of the spacer ring. Place the drive plate on the torque converter. Apply Loctite to the bolts. Install the bolts and washers that hold the FIGURE 4-329 4767 surface of the torque converter flange to the top of the spacer ring. In this example this dis- tance measured .30 mm (.0118"). FIGURE 4-332 4770 The required torque converter gap is .10 – .30 mm (.0039 – .0118"). To create a drive plate to the torque converter. 3.

Lift up the torque converter assembly FIGURE 4-330 4768 FIGURE 4-333 4771 gap that falls within the required span, select a .50 mm (.01968") thick shim washer. and install it into the bell housing. See Figure 4-310. Power Take-off Shaft 1. Install the lower snap ring into the housing bore. See Figures 4-311 and 4-92 (shaft A). Place the bearing down into the bore until it rests on the snap ring. FIGURE 4-331 4769 4-80 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual