daewoo — Daewoo Wheel Loader Shop Manual

Assembly 1. Grease the bearing needles and install them in a planetary gear. Grease the thrust washers and install them into the planetary carrier. See Figure 4-383. Cool the planetary gear to shrink it. Insert the gear into the carrier. Slide the shaft through the carrier and the gear. Install the gear shaft carefully so that the pin hole in the shaft aligns with the pin hole in the carrier. Install 4 planetary gears on one side of the carrier. 3. Install the 2 remaining planetary gears. Install the roll pins into all the planetary gears. See Figure 4-385. FIGURE 4-385 4823 4. Insert the output gear into the transmission housing. See Figure 4-386. FIGURE 4-383 4821 2.

Install the sun gear and its thrust washers. See Figure 4-384. The washer with the small- est diameter hole must be at the bottom of the sun gear. FIGURE 4-386 4824 5. Install the planetary carrier into the output gear. See Figure 4-387. The long hub of the planetary carrier must face down into the out- put gear. FIGURE 4-384 4822 FIGURE 4-387 4825 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-91