25. Install the output flange seal. See Figure 4-407. Use a seal driver to move the seal down until it bottoms on the snap ring. Apply grease to the rubber lips of the seal. 28. Install the lock plate on the bolts. See Figure 4-410. FIGURE 4-410 4848 FIGURE 4-407 4845 29. Apply Loctite to 2 bore plugs. Install the plugs into the bores on either side of the output flange. See Figure 4-411. 26. Insert the output flange into the transmission. See Figure 4-408. FIGURE 4-411 4849 FIGURE 4-408 4846 27. Apply sealing compound to the disc. Insert the bolts in the disc. See Figure 4-409. Install the disc in the flange and tighten the bolts. 30. Install a new gasket for the speedometer drive.
Assemble the parts for the speedometer drive and bolt them to the transmission. See Figure 4-412. FIGURE 4-409 4847 FIGURE 4-412 4850 4-96 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual