daewoo — Daewoo Wheel Loader Shop Manual

21. Insert the ball bearing from the short end of the shaft until it bottoms on the flange. See Figure 4-403. Install the needle bearing in the other end of the shaft. 23. Install a snap ring into the groove above the bearing. See Figure 4-405. Push the snap ring upward until it is forced against the upper part of its groove. Use a feeler gauge to mea- sure the gap between the bottom side of the snap ring and the top side of the outer bear- ing race. Choose a shim thickness that is equal to the measured gap. In this example the gap measured 1.7 mm (.0669"). Therefore a shim was chosen that had a thickness of FIGURE 4-403 4841 22. Install the shaft into the transmission. See Figure 4-404.

Be certain that the bearing bot- toms on the snap ring inside the bore. FIGURE 4-405 4843 1.7 mm. 24. Remove the snap ring. See Figure 4-406. Install the shim washer that was chosen in the FIGURE 4-404 4842 FIGURE 4-406 4844 previous step. Install the snap ring into its groove. Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-95