17. On each end of the sun gear, align the thrust washer in preparation for installing the output shaft. Install the bolts that hold the disengagement gearbox to the transmission. See Figure 4-399. Tighten the bolts to 25 Nm (18 ft lb). Remove the assembly studs. 19. Install the snap ring into its groove. See Figure 4-401. Hold the snap ring down to the bottom of its groove. Then use a feeler gauge to measure the gap between the bottom of the snap ring and the top of the outer race of the bearing that is mounted below the snap ring. This gap must be .3 – .5 mm (.0118 – .0196"). In this example, the gap measured 1.5 mm (.059").
In this example the correct gap can be achieved by installing a shim washer of 1.2 mm thickness. FIGURE 4-399 4837 18. Rotate the transmission 180°. Make sure that the roller bearing is bottomed in the bore. See Figure 4-400. FIGURE 4-401 4839 1.5 mm (.059") total gap -1.2 mm (.047") shim thickness .3 mm (.0118") gap with shim installed 20. Insert the spacer washer of the thickness determined in the previous step. See Figure 4-402. Install the snap ring on top of the washer. FIGURE 4-400 4838 NOTE Some of the following steps describe taking a 1measurement and using the measurement to cal- culate a shim thickness. The measurements shown in these steps are an example only.
Be sure to take your own measurements on the transmission you are working on, and perform your own calculation to derive the correct shim thickness for your transmission. FIGURE 4-402 4840 4-94 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual