27. Install the spacing and housing washers on the stator hub. See Figure 4-460. Install the gasket over the bolt holes on the outer cir- cumference of the pump wheel. FIGURE 4-462 4900 30. Install all the bolts and washers. Cross tighten the bolts to a final torque of 25 Nm (18 ft lb). See Figure 4-463. FIGURE 4-460 4898 28. Install the assembled stator into the turbine wheel. See Figure 4-461. FIGURE 4-463 4901 31. Install the square sealing ring. See Figure 4-464. FIGURE 4-461 4899 29. Apply grease to the gasket and housing washers in the pump wheel. Set the pump wheel on the impeller cover. See Figure 4- 462.
Align the match marks on the impeller cover and the pump wheel that were made during disassembly. Install two bolts 180° apart, and alternately tighten these bolts until the pump wheel and the impeller cover are flush at all points. FIGURE 4-464 4902 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-107