daewoo — Daewoo Wheel Loader Shop Manual

23. Install the turbine wheel assembly into the impeller cover. See Figure 4-456. 25. Measure the distance from the flange face to the top of the bearing washer. See Figure 4-458. In this example, this distance measured 15.3 mm (.602"). This is measurement A. FIGURE 4-456 4894 24. Install the collar shim, thrust bearing, and bearing washer into the turbine wheel. See Figure 4-457. FIGURE 4-458 4896 26. Measure the distance between the stator flange face and the top of the stator bearing inner race. See Figure 4-459. In this example, this distance measured 16.9 mm (.665"). This is measurement B.

To calculate the total end play, and shim washer thickness necessary, perform the following calculations. FIGURE 4-457 4895 NOTE The following steps describe taking measurements and using the measurements to calculate a shim thickness. The measurements shown in these steps are an example only. Be sure to take your own measurements and perform your own calcula- tion to derive the correct shim thickness for your torque converter. FIGURE 4-459 4897 16.9 mm (.665") measurement A -15.3 mm (.602") measurement B 1.6 mm (.0629") total end play The maximum allowable end play is .2 mm (.0078"). To create end play in the middle of the allowable range, choose a 1.5 mm (.059") shim.

1.6 mm (.0629") total end play -0.1 mm (.0039") desired end play 1.5 mm (.059") shim thickness 4-106 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual