18. Set the cover ring over the plate pack. See Figure 4-451. Install the bolts into the cover ring and plate pack. Tighten bolts to 35 Nm (26 ft lb). 20. Remove the snap ring. See Figure 4-453. Install beneath the snap ring, a shim washer with the thickness measured in the previous step (1.40 mm). Install the snap ring. FIGURE 4-451 4889 FIGURE 4-453 4891 NOTE 21. Install the hub in the turbine wheel. See Figure 4-454. Install the bolts and tighten to 25 Nm (18 ft lb). The following steps describe taking measurements to calculate a shim thickness. The measurements shown in these steps are an example only.
Be sure to take your own measurements to derive the cor- rect shim thickness for your torque converter. 19. Use compressed air to move the piston. Then measure the gap between the snap ring and cup spring. See Figure 4-452. In this example, this gap measured 1.40 mm (.055"). FIGURE 4-454 4892 22. Heat the ball bearing and install it on the hub shaft. See Figure 4-455. Install the snap ring. FIGURE 4-452 4890 FIGURE 4-455 4893 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-105