13. Before installation, expand the square seal rings so that they make good contact with the sides of the grooves. Install the square seal rings into the grooves on both the inner and outer circumference of the piston. See Figure 4-446. Coat the rings with grease. 16. Install the plate pack into the impeller cover. See Figure 4-449. Install the plates in the fol- lowing order. Two plates with bolt holes on the outer circumference. One plate with tangs on the inner circumference. One plate with bolt holes on the outer circumference. FIGURE 4-446 4884 FIGURE 4-449 4887 14. Install the piston into the impeller cover. See Figure 4-447. 17. Install the cup spring and the snap ring.
The cup spring determines the gap setting for the plate pack. See Figure 4-450. FIGURE 4-447 4885 FIGURE 4-450 4888 15. Install the cylindrical rollers into the impeller cover as shown in Figure 4-448. FIGURE 4-448 4886 4-104 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual