8. Turn the stator over and work from the other side. Use a tool to hold down the spring cap. Install two bearing rollers at two points, 180° apart. This will make it easier to install the remaining rollers. See Figure 4-441. Then install all the remaining rollers. 10. Turn the stator over and work from the other side. Install the shim washer. Install the thrust plate. See Figure 4-443. FIGURE 4-443 4881 11. Insert the thrust washer into the pump wheel. Install the thrust bearing on top of the thrust washer. See Figure 4-444. FIGURE 4-441 4879 9. Install the thrust washer. Then insert the bearing until it bottoms on the shoulder. See Figure 4-442. FIGURE 4-444 4882 12.
Set the stator into the pump wheel. See Figure 4-445. FIGURE 4-442 4880 FIGURE 4-445 4883 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-103