2. Insert the bolts into the pump flange. Tighten the bolts to 25 Nm (18 ft lb). See Figure 4-435. 5. Apply grease to the cylindrical roller, compression spring, and the spring cap. See Figure 4-438. Insert these parts into the freewheeling outer bore. FIGURE 4-435 4873 FIGURE 4-438 4876 3. Heat the stator. Insert the freewheeling outer race into the stator. See Figure 4-436. Install the snap ring. 6. Heat the ball bearing and slide it to the shoul- der on the long end [24 mm (.944")] of the freewheeling inner race. See Figure 4-439. FIGURE 4-436 4874 4. Figure 4-437 shows the parts that will be installed into the stator. FIGURE 4-439 4877 7. Install the spacer washer. See Figure 4-440.
Install the freewheeling inner race into the sta- tor. Use caution to prevent damage to parts. FIGURE 4-437 4875 FIGURE 4-440 4878 4-102 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual