17. Remove the thrust bearing and spacer washer from the stator. See Figure 4-430. 20. Remove the bolts that hold the pump flange to the pump wheel. See Figure 4-433. Remove the pump flange. FIGURE 4-430 4868 FIGURE 4-433 4871 18. Press the freewheeling inner race out of the stator. See Figure 4-431. Use caution to pre- vent damage to the bearing and spacer washer. Assembly 1. Thread 2 assembly studs into the pump wheel. Slide a new gasket for the pump flange over the assembly studs. See Figure 4-434. Set the pump flange into position on the pump wheel. Properly align the pump flange with the oil supply hole in the pump wheel. FIGURE 4-431 4869 19. Remove the snap ring.
Press the freewheeling outer race out of the stator. See Figure 4-432. FIGURE 4-434 4872 FIGURE 4-432 4870 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-101