steering inertia is fed back to one of the C ports, the poppet (1, Figure 5-4) compresses its spring and directs the high pressure oil to the tank port T. Oil then pushes the spool (2) to close the passage to port T. This opens a path to the relief valve piston (3, Figure 5-4). Oil presses the piston (3) against its spring until a path is opened to the tank port T. This releases the pressure and protects the circuit components by keeping the maximum pres- sure below the desired level. If a vacuum is created in the opposite C port, oil will be drawn from the T passage, through the check ball (4). This will prevent cavitation.
steering unit, oil from port P flows through port CF and into the drilled passage in the spool. At this time oil flowing out of CF is blocked at the control spool of the steering unit. This raises the pressure in port CF. At this time, port LS is open to the chamber on the far left side of the priority valve. Port LS is not open to the chamber on the far right side of the valve. As oil flows through the drilled passage in the spool, pressure builds on the right side of the spool but pressure is low on the left side of the spool because oil can drain into port LS.
When oil pressure on the right side of the spool rises above the force of spring (2, Figure 5-5), the spool (1) shifts to the left. This allows pump flow at port P to flow out both ports CF and EF. Now both the loader supply line and the steering supply line are charged with flow from the steering pump. Whenever the steering wheel is turned, the spool in the steering unit directs some oil flow back to port LS. This equalizes the oil pressure on both ends of the spool (1). The spring now shifts the spool to the right. This closes off the passage from port P to port EF. This makes all steering pump flow now available only to the steering circuit from port CF.
Priority Valve Operation Oil output from the steering pump flows through the priority valve to both the loader supply line and to the steering circuit. During operation of the steering wheel, the priority valve shifts and supplies pump flow only to the steering circuit. This results in smooth operation of the steering circuit. At rest, the spool (1, Figure 5-5) maintains an open path between inlet port P and steering outlet 1. Spool 2. Spring P Pressure Port CF Steering Supply Port EF Loader Supply Port LS Pilot Port FIGURE 5-5 4934 port CF. Port EF is kept closed by the force from spring (2). The spool (1) contains a drilled passage.
The passage is open to port CF and is also open to both ends of the spool. At the neutral position of the 5-4 POWER STEERING MEGA 300-III Shop Manual