daewoo — Daewoo Wheel Loader Shop Manual

1. Poppet 2. Spool 3. Relief Valve Spool 4. Check Ball 5. Spring 6. Orifice FIGURE 5-4 4933 into the tank. (9, Figure 5-2) works as a manual pump when the steering wheel is turned. The gerotor will work when the input torque to the steering wheel is less than 12 kg m (87 ft lb). If the necessary input torque is greater than this, the gerotor will not func- tion. When the steering wheel is turned, the gerotor creates a vacuum that draws oil from port T. See Figure 5-2. The gerotor pumps this oil through the control spool and into the steering cylinders. Return oil flows back to the spool and is used to lubricate the steering unit (1, Figure 5-2).

The return oil then flows back into the tank line and is recirculated back to the gerotor and the steering cylinders. Left Turn The spool (2, Figure 5-3) is engaged with the spline of the steering shaft. When the steering wheel is turned to the left, the spool turns. The sleeve (1) is connected to the spool (2) by centering springs (3). When the spool turns, the sleeve turns. The sleeve turning angle is about 10° less than the spool turning angle. This allows the longitudinal slots in the spool to align with the ports in the sleeve.

When the steering wheel is turned to the left, oil from port P on the steering unit (1, Figure 5-2) is directed through the control spool in the steering unit, out port L and into the steering cylinders (8). The amount of oil flow metered to port L is controlled by the amount of steering wheel rotation. Excess oil flow through port P that is not metered to port L, is directed by the spool to port T and is then directed through the oil cooler and into the tank. Cushion Valve Operation The cushion valve (2, Figure 5-2) absorbs any excessive peak pressure that may be generated during initial movement of the steering wheel or during a change in steering direction.

The cushion valve also prevents excessive high pressure and cavitation that can result from steering load inertia. The C ports in the cushion valve are connected in parallel to the steering cylinders. Port T in the cushion valve is connected to the tank line. See Figure 5-4. If a high pressure spike caused by Gerotor If the engine or pump is not operating, the gerotor MEGA 300-III Shop Manual POWER STEERING 5-3