daewoo — Daewoo Wheel Loader Shop Manual

1. Steering Unit 2. Cushion Unit 3. Relief Valve 4. Control Valve 5. Priority Valve 6. Oil Cooler 7. Accumulator 8. Steering Cylinder 9. Gerotor 4932 FIGURE 5-2 Neutral Operation With the steering wheel in the neutral position (wheels turned neither right nor left), the spool (2, Figure 5-3) and sleeve (1) are stationary at the position where the center pin (6) becomes centered in the spool space by the centering springs (3). Oil flow through the load sensing line (LS), port L, port R, and port T are bypassed to the tank line and the oil supply (P) is blocked by the directional spool in the steering unit (1, Figure 5-2).

Even if an external force is applied to the steering cylinder, the steering unit is protected because the oil path is blocked by the directional spool. 1. Sleeve 2. Spool 3. Centering Spring 4. Spool 5. Sleeve 6. Center Pin 7. Drive Shaft Right Turn The spool (2, Figure 5-3) is engaged with the spline of the steering shaft. When the steering wheel is turned to the right, the spool turns. The sleeve (1) is connected to the spool (2) by centering springs (3). When the spool turns, the sleeve turns. The sleeve turning angle is about 10° less than the spool turning angle. This allows the longitudinal slots in the spool to align with the ports in the sleeve.

Oil from port P on the steering unit (1, Figure 5-2) travels through the control spool and is FIGURE 5-3 3773 directed to port R which directs the oil to the steering cylinders. The amount of oil flow metered to port R is controlled by the amount of steering wheel rotation. Excess oil flow through port P that is not metered to port R, is directed by the spool to port T and is then directed through the oil cooler and 5-2 POWER STEERING MEGA 300-III Shop Manual