POWER STEERING Power Steering System The steering unit contains a gerotor. This allows the operator to steer the machine when the engine is not running or when the steering pump has failed. The gerotor functions as a manual hydraulic pump that is powered by the rotation of the steering wheel. Rotating the steering wheel will cause the gerotor to draw oil from the hydraulic tank and send this oil to the steering cylinders. Power Steering Unit The machine contains a fully hydraulic steering unit. See Figure 5-1. Rotating the steering wheel controls hydraulic flow through the steering valve. See Figure 5-2. Figure 5-2 contains the hydraulic schematic for the steering system.
The steering valve meters the volume of pump flow that is supplied to the steering cylinders. The shaft that is rotated by the steering wheel is attached to the spool (8, Figure 5-1) by the engage- ment of a spline. The spool is surrounded by a sleeve (3). The spool and sleeve are connected by the centering spring (2). At the steering wheel neutral position, the center pin does not contact the spool. A driveshaft (9) extends through the spool. The upper end of the driveshaft engages the center pin (4). The lower end of the driveshaft engages the spline in the gerotor (6). 1. Bearing 2. Centering Springs 3. Sleeve 4. Center Pin 5. Check Valve 6. Gerotor 7. End Cap 8. Spool 9. Drive Shaft 10.
Housing FIGURE 5-1 3772 MEGA 300-III Shop Manual POWER STEERING 5-1