daewoo — Daewoo Wheel Loader Shop Manual

Hydraulic Pump The construction and operation of pumping sections one and two are the same. As the vane (4, Figure 7-3) rotates from position E to position A, the area between the vanes increases due to the shape of the cam ring. This creates a vacuum. The vacuum draws fluid from the tank, through the pump inlet (8) and into the space between the vanes. As the vanes rotate between position A and position B, the area between the vanes decreases due to the shape of the cam ring (1). This pressurizes the fluid between the vanes as it is forced out the pump discharge outlet (3). The pumping section has two inlets (5 and 8) and two outlets (3 and 10).

The hydraulic pump contains three vane type pumping sections. See Figure 7-2. The first pumping section supplies fluid for the boom and bucket cylinders. Pumping volume for the first section is 81.5 cc per revolution. The second pumping section supplies fluid for the steering cylin- ders and has a pumping volume of 67.5 cc per revolution. The third pumping section supplies fluid for pilot flow and has a volume of 18 cc per revolu- tion. The pump is driven by a shaft that is driven by the torque converter. 1. Boom/Bucket Pumping Section 2. Steering Pumping Section 3. Pilot/Brake Pumping Section 1. Cam Ring 2. Rotor 3. Outlet 4. Vane 5. Inlet 6. Slot 7. Passage 8. Inlet 9. Insert 10.

Outlet A-F Positions of Vanes Pump Discharge Oil Pump Inlet Oil FIGURE 7-2 4034 FIGURE 7-3 4035 Pressurized oil flows into the passages (7, Figure 7-3) on the rotor (2) and is directed into the slots (6) behind the vanes (4). This allows fluid to build up between the insert (9) and the vane (4). This forces the vanes (4) up against the cam ring (1) to create a tight seal between the cam ring and vane. Mega 300-III Shop Manual HYDRAULIC SYSTEM 7-3