daewoo — Daewoo Wheel Loader Shop Manual

28. Remove the wear plate (42, Figure 7-34) from the cam ring (44). Wind a rubber band around the rotor to prevent the vanes from falling out of their slots. Remove the rotor and vane assembly (43). Remove the vanes from the rotor. Mark down the slot that each vane was removed from. During assembly, this will make it possible to return each vane to the slot that it was removed from. 30. Remove the seal (46, Figure 7-36) from the 46. Seal 42. Wear Plate 43. Vane Assembly 44. Cam Ring FIGURE 7-36 4068 pressure plate. Pump Assembly 1. Seals FIGURE 7-34 4066 29. Remove the wear plate (45, Figure 7-35) from 45. Wear Plate FIGURE 7-37 4069 1.

Put the seals (1, Figure 7-37) into position on the pressure plate. FIGURE 7-35 4067 the pressure plate. Mega 300-III Shop Manual HYDRAULIC SYSTEM 7-11