daewoo — Daewoo Wheel Loader Shop Manual

2. Install the wear plate (5, Figure 7-38) on the pressure plate. Insert the vanes into the rotor (4). The leading edge of each vane must be toward the direction of pump rotation. Hold the vanes in place by winding a rubber band around the rotor. 4. Set the cartridge (8, Figure 7-40) into the pump housing. 8. Cartridge Set the rotor (4) on the pressure plate (5). Set the cam ring (3) over the rotor (4). Set the wear plate (2) on top of the rotor and cam ring. 2. Wear Plate 3. Cam Ring 4. Rotor 5. Wear Plate FIGURE 7-40 4072 5. Set the seal ring (9, Figure 7-41) on the cartridge. 9. Seal Ring FIGURE 7-38 4070 3. Place the seals (7, Figure 7-39) on the pres- sure plate (6).

Set the pressure plate on top of the wear plate (2). Install the bolts in the holes closest to the arrow that is in the same direc- tion as the arrow on the cam ring (3). Tighten the bolts. FIGURE 7-41 4073 6. Press the bearing (11, Figure 7-42) onto the shaft (10). 6. Pressure Plate 7. Seals 10. Shaft 11. Bearing FIGURE 7-39 4071 FIGURE 7-42 4074 7-12 HYDRAULIC SYSTEM Mega 300-III Shop Manual