13. Place the body assembly (17, Figure 7-49) onto the pump housing. 16. Place the wear plate (24, Figure 7-52) over the pressure plate. 17. Body Assembly 20. Pressure Plate 22. Seals 23. Cam Ring 24. Wear Plate 25. Pressure Plate FIGURE 7-49 4081 14. Turn the pump upside down. Install and tighten the bolts (18, Figure 7-50). FIGURE 7-52 4084 Install the vanes into the rotor. The leading edge of each vane must be toward the direc- tion of pump rotation. Hold the vanes in place by winding a rubber band around the rotor. Set the rotor on the wear plate (24, Figure 7-52). Remove the rubber band. 18. Bolts Set the cam ring (23) over the rotor. Set the wear plate (25) on top of the cam ring.
Install the seals (22) on the pressure plate (25). Place the pressure plate (20) on top of the wear plate (25). Insert the bolts into the pressure plate (20) and tighten the bolts. FIGURE 7-50 4082 17. Insert the assembled cartridge (26, Figure 7-53) into the pump housing. 15. Install the seals (19, Figure 7-51) on the pres- sure plate. 26. Cartridge 19. Seals FIGURE 7-53 4085 FIGURE 7-51 4083 7-14 HYDRAULIC SYSTEM Mega 300-III Shop Manual