daewoo — Daewoo Wheel Loader Shop Manual

Manually Controlled Pilot Valve Pilot Valve Operation The lever handle is positioned on the right side of the operator's seat. This single lever controls the following machine functions; raise boom, lower boom, bucket crowd, and bucket dump. The lever positions are identified as follows: When no force is applied to the lever (1, Figure 7-74), the return spring (4) positions the lever at the neutral position. When the lever is moved, plunger (5) is moved, which pushes down the return spring (4). At the same time, spool (2) is moved by spring (3). When spool (2) moves down, a groove (6) in the spool opens the pilot pressure line to the line that the lever controls.

This allows the pilot pres- sure to flow to the boom or bucket control valve, where the pilot pressure operates the control valve. When the lever is completely moved in one direc- tion, the solenoid (7) energizes the electro-magnet (8) and holds the lever in the fully moved position. F – Float L – Lower N – Neutral R – Raise H – Hold Position Bucket Crowd D – Bucket Dump HR – Holds Lever in Raise Mode 1. Lever 2. Valve Spool 3. Regulating Spring 4. Return Spring 5. Plunger 6. Spool Groove 7. Solenoid 8. Electro-magnet FIGURE 7-74 4108 Mega 300-III Shop Manual HYDRAULIC SYSTEM 7-23