daewoo — Daewoo Wheel Loader Shop Manual

Load Sensing Cartridge In the hydraulic circuit that is supplied by the steering pump, maximum pressure is limited to 175 +30 -10 kg/cm 2 (2489 +427 -142 psi). Pressure is limited by load sensing cartridge C4 in the unloading valve. See Figure 7-76. The load sensing cartridge can be adjusted to obtain the correct maximum pressure. Turning the load sensing adjusting screw clockwise will raise the relief pres- sure. Turning the screw counterclockwise will lower the relief pressure. Pressure can be monitored at the steering pump outlet. Brake Pressure Checks The maximum loading and unloading pressure in the brake pilot valve is 120 – 140 kg/cm 2 (1,706 – 1,991 psi).

This pressure can be checked at gauge port ULTP which is located at the upper part of the brake pilot valve. See the hydraulic schematic in Figure 7-116. Service brake outlet pressure is 60 ± 5 kg/cm 2 (853 ± 71 psi). Pressure can be checked at the gauge port on the outlet side of the brake pedal valve. Pressure to the lever controlled pilot valves should be 30 ± 5 kg/cm 2 (427 ± 71 psi). Pressure can be checked at the TP port on the brake pilot valve. See the hydraulic schematic in Figure 7-116. UNLOADING VALVE FIGURE 7-76 4110 Unloading Valve The unloading valve in the steering pump circuit is set to unload at 160 ±5 kg/cm 2 (2275 ±71 psi). See Figure 7-70.

The unloading valve cartridge C1 can be adjusted to obtain the correct unloading pres- sure. See Figure 7-76. Turning the C1 adjusting screw clockwise will raise the unloading pressure. Turning the screw counterclockwise will lower the unloading pressure. Pressure can be monitored at the steering pump outlet. 7-26 HYDRAULIC SYSTEM Mega 300-III Shop Manual