20. Install the piston nut (1, Figure 7-107) and tighten it with an impact wrench. Then use a torque wrench to tighten the nut (1) to the specified torque. Use a pipe extension on the torque wrench handle if necessary, to achieve the specified torque. 21. Slide the rod assembly into the cylinder tube. Align the punch mark (1, Figure 7-109) with the port (2) in the cylinder tube. This will align the hole (3) in the cylinder head with the port (2). 1. Piston Nut 1. Punch Mark 2. Port 3. Hole FIGURE 7-107 3853 FIGURE 7-109 3855 It is also possible to rotate the handle of the torque wrench with a hoist and a lifting sling for a cushion. See Figure 7-108. 22.
Install the bolts in the cylinder head and tighten them to the torque specified in the bolt torque chart. See Figure 7-110. Double check to make sure that the hole in the cylinder head is aligned with the port in the cylinder tube. FIGURE 7-108 3854 After the nut has been tightened, check to see that the cushion flange moves. FIGURE 7-110 3856 NOTE After rebuilding a cylinder, or after loosening a cylinder hydraulic line, air must be bled from the hydraulic system. To bleed air from the system, first extend and retract a cylinder (or pair of cylinders) about 5 times at low engine RPM. Stop the cylinder about 100 mm (4") short of full extension and full retraction.
Then fully extend and retract the cylinder about 5 times, also at low engine RPM. Mega 300-III Shop Manual HYDRAULIC SYSTEM 7-37