15. Install 2 backup rings (1, Figure 7-102). One ring fits on either side of the slipper seal (2). 17. Set the cylinder rod (1, Figure 7-104) into a repair fixture (2). Securely clamp the rod to the fixture. Exercise caution to prevent nicks or scratches to the chrome plated area of the rod. The chrome plated area is the oil sealing surface of the rod. 1. Backup Ring 2. Slipper Seal 1. Cylinder Rod 2. Repair Fixture FIGURE 7-104 3850 18. Slide the cylinder head assembly (1, Figure 7-105) onto the cylinder rod (2). Use caution to prevent the threads on the rod from damaging the seals inside the cylinder head. FIGURE 7-102 4031 1. Cylinder Head 2. Cylinder Rod 16.
Install the wear ring (1, Figure 7-103) on the piston. 1. Wear Ring FIGURE 7-105 3851 19. Install the cushion flange (1, Figure 7-106) on the cylinder rod (2). Slide the piston assembly (3) onto the cylinder rod (2). 1. Cushion Flange 2. Cylinder Rod 3. Piston Assembly FIGURE 7-103 3849 FIGURE 7-106 4030 7-36 HYDRAULIC SYSTEM Mega 300-III Shop Manual