11. Apply grease or hydraulic oil to the corner of the piston at position A. See Figure 7-98. 14. Insert one end of the slipper seal (1, Figure 7-101) into its groove. Use your hand to slide the other end of the slipper seal into the groove. 1. Slipper Seal FIGURE 7-98 3844 12. Insert one end of the backup ring into its groove. See Figure 7-99. Use your hand to slide the other end of the ring into the groove. 1. Backup Ring FIGURE 7-101 3847 IMPORTANT Before the piston is inserted into the cylinder tube, make sure that the slipper seal is no longer expanded. If the seal is still expanded, it could catch on the threaded portion of the cylinder tube.
An expanded seal could also jam inside the cylinder tube. FIGURE 7-99 3845 13. Use warm water to expand the slipper seal. See Figure 7-100. This will make the seal easier to install. Set the slipper seal in 60 – 100°C (140 – 212°F) water for 5 minutes or longer. FIGURE 7-100 3846 Mega 300-III Shop Manual HYDRAULIC SYSTEM 7-35