6. Use grease or an adhesive to hold the split backup ring (1, Figure 7-93) in place. Install the split backup ring (1) in the groove closest to the flange on the cylinder head. 9. Use a seal installing jig to install the dust seal into the cylinder head. See Figure 7-96. Install the snap ring. 1. Split Backup Ring 2. Continuous Backup Ring FIGURE 7-93 3840 7. Place the continuous backup ring in warm water. See Figure 7-94. The water tempera- ture should be 30 – 50°C (86 – 122°F). Leave the ring in the water for 2 – 3 minutes. Slide the continuous backup ring (2, Figure 7-93) over the cylinder head and into its groove. FIGURE 7-96 3842 10.
On the piston, check the corners of the grooves that the piston rings will be mounted in. See Figure 7-97. If any burrs, roughness, or sharp edges (1) are present, use an oil stone to smooth the roughened areas and dull the sharp edges. 1. Burrs FIGURE 7-94 3839 8. Install an O-ring over each of the backup rings. See Figure 7-95. FIGURE 7-97 3843 FIGURE 7-95 3841 7-34 HYDRAULIC SYSTEM Mega 300-III Shop Manual