1. Apply grease to the inner part of the cylinder head and to the U-packing groove. See Figure 7-88. 3. Insert one side of the U-packing in its groove. See Figure 7-90. FIGURE 7-90 3836 4. Carefully push down on the other side of the U-packing until the entire U-packing is seated in its groove. See Figure 7-91. FIGURE 7-88 3834 2. Install the split backup ring into its groove by compressing the ring. See Figure 7-89. Make sure that the ends of the ring do not overlap. FIGURE 7-91 3837 5. Check to be sure that the U-packing and the backup ring are correctly installed by pushing with your hand on the inner diameter of the U-packing. See Figure 7-92.
FIGURE 7-89 3835 NOTE The U-packing can be installed by hand or by using a seal installing jig. The jig should be made of copper, aluminum, or plastic. If a jig is used, be sure that the jig does not have sharp edges that could damage the U-packing. FIGURE 7-92 3838 NOTE There are 2 backup rings used on the outside of the cylinder head. One backup ring is continuous. The other backup ring is open, split by an angled cut. Mega 300-III Shop Manual HYDRAULIC SYSTEM 7-33