daewoo — Daewoo Wheel Loader Shop Manual

5. Do not remove the slipper seal, backup ring, and back ring from the piston if these 3 items are not scratched or damaged. See Figure 7-84. Once these 3 items are removed from the piston, they must be replaced. They cannot be reused. Exercise caution when removing the slipper seal to prevent damage to the piston O-ring groove. 7. Use caution to prevent damage to any parts other than the U-packing (1, Figure 7-86). Remove the U-packing (1). Remove the O-ring (2), and ring (3). 1. U-Packing 2. O-Ring 3. Ring Remove the wear rings from the piston. FIGURE 7-86 3832 Cylinder Assembly NOTE Check the cylinder head grooves for the U-packing and dust seal.

If the edges of the grooves are sharp or have burrs, use an oil stone to smooth the surface. See Figure 7-87. FIGURE 7-84 3830 6. When disassembling the cylinder head do not remove the slipper seal, backup ring, back ring, or dust seal unless the items are scratched or damaged. If the seals are removed from the head, they must be replaced. They cannot be reused. Remove the snap ring (1, Figure 7-85). Use a screwdriver to remove the dust seal (2) from the head. 1. Snap Ring 2. Dust Seal FIGURE 7-87 3833 FIGURE 7-85 3831 7-32 HYDRAULIC SYSTEM Mega 300-III Shop Manual