Hydraulic Cylinder Disassembly 3. Set the cylinder rod assembly into a repair fixture and secure the rod in place. See Figure 7-82. Use a power wrench and socket to remove the nut that holds the piston on the rod. NOTE Keep on hand a container large enough to hold all of the oil in the cylinder being repaired. When the cylinder rod and head are removed, the oil will run out of the cylinder. 1. Use an allen wrench to remove the bolts that hold the cylinder head to the cylinder tube. See Figure 7-80. FIGURE 7-82 3828 4. Remove the piston nut (1, Figure 7-83), piston assembly (2), cushion flange (3), and cylinder head assembly (4). 1. Piston Nut 2. Piston Assembly 3. Cushion Flange 4.
Cylinder Head Assembly FIGURE 7-80 3826 2. Support the cylinder rod with a lifting sling. See Figure 7-81. Slide the cylinder rod out of the cylinder tube. Rotate the cylinder rod slightly as it is being pulled from the cylinder tube. This will make it easier to pull the rod out of the tube. FIGURE 7-83 3829 FIGURE 7-81 3827 Mega 300-III Shop Manual HYDRAULIC SYSTEM 7-31