Hydraulic Cylinder Troubleshooting (Continued) 7-30 HYDRAULIC SYSTEM Mega 300-III Shop Manual Problem Possible Cause Remedy Slow bucket and boom movements (continued). 7. Relief valve sticking. Disassemble and inspect cartridge. Clean or replace cartridge. 8. Air in pressure line. Perform cylinder bleeding procedure to remove air. Tighten or replace pressure line. 9. Damaged pipe or hose. Replace pipe or hose. 10. Worn cylinder seals. Replace worn parts. Low pressure, shown by weak upward movement of boom and bucket. 1. Same cause and remedy (1, 3, 4, 6, 7, and 10) of previous problem. 2. Low pump output due to dirty discharge pipes. Remove and clean pump discharge pipes. 3.
Relief valve spring is weak. Relief valve poppet worn. Replace worn parts. Cylinder drops when control valve is in neutral. 1. Worn plunger in control valve. Replace plunger. 2. Stuck overload relief valve due to worn seat surface. Replace worn parts. 3. Loose pipes or joints. Tighten parts. 4. Worn piston seal on hydraulic cylinder. Replace seal. Vibration or excessive noise. 1. Excessive resistance in pump intake line. Inspect intake lines and clean or replace as necessary. 2. Air being drawn into intake line. Inspect pipe joints and tighten. 3. Chattering relief valve. Change oil, replace valve. Air bubbles in oil. 1. Wrong type of operating oil. Drain and fill with proper type of oil. 2.
Oil level too low. Raise to proper level. 3. Air trapped in system. Perform cylinder bleeding procedure to remove air. Frequent rubber hose damage. 1. System pressure too high. Adjust relief valve pressure. 2. Hoses breaking due to contact with other machine parts. Restrain hoses to prevent contact.