Hydraulic Cylinder Troubleshooting Mega 300-III Shop Manual HYDRAULIC SYSTEM 7-29 Problem Possible Cause Remedy Oil leaking between cylinder head (16) and piston rod (18). (Index nos. refer to Figure 7-77.) 1. Foreign material in U-ring (3). Remove foreign material. 2. Scratches in U-ring (3). Replace U-ring (3). 3. Damage to U-ring (3). Replace U-ring (3). 4. Foreign material in dust seal (2). Remove foreign material. 5. Scratches in dust seal (2). Replace dust seal (2). 6. Damage to dust seal (2). Replace dust seal (2). 7. Foreign material in seal O-ring (4). Remove foreign material. 8. Scratches in seal O-ring (4). Replace O-ring (4). 9. Damage to seal O-ring (4). Replace O-ring (4). 10.
Scratches on sealing surface of piston rod (18). If scratches are not deep, hone with an oil stone and lubricate. If scratches are deep, replace piston rod (18). 11. Deep scratches on inner surface of bushing (15). Replace bushing. Oil leaking between cylinder head (16) and cylinder tube (13). 1. Damage to O-rings (14). Replace O-rings (14). Oil leaking from welded area of cylinder tube (13). 1. Damage to welded area. Replace cylinder tube (13). Cylinder drops from pull of gravity. 1. Light scratches on sealing surface of cylinder tube (13). Hone out scratches with oil stone. 2. Deep scratches on sealing surface of cylinder tube (13). Replace cylinder tube (13). 3.
Deep scratches on sealing surface of piston O-rings (10). Replace O-rings (10). 4. Foreign material in U-ring (3). Remove foreign material. 5. Scratches in U-ring (3). Replace U-ring (3). 6. Damage to U-ring (3). Replace U-ring (3). 7. Nylon wear rings (7) twisted. Replace nylon wear rings (7). 8. Nylon wear rings (7) scratched. Replace nylon wear rings (7). 9. Nylon wear rings (7) have other damage. Replace nylon wear rings (7). Slow bucket and boom movements. 1. Reduced oil flow due to dirty filter or dirty intake line. Disassemble and clean parts. 2. Air drawn into circuit through loose connections. Tighten the intake connections. 3. Reservoir oil level too low.
Fill reservoir to specified level. 4. Relief valve pressure setting incorrect. Adjust relief valve pressure. 5. Damaged pump shaft or pump drive sleeve. Replace damaged parts. 6. Pump worn or damaged internally. Replace worn or damaged parts.