Daily Or Every 10 Operating Hours 1. Dipstick 2. Oil Filler Cap Check Engine Oil Level Check the level of the engine oil every day before starting the engine. Remove the engine oil dipstick. See Figure 3-11. The oil level must be between the low and full marks. To add oil, remove the oil filler cap. See Figure 3-12. FIGURE 3-13 4439 Check Hydraulic System Oil Level Start the engine and move the machine to a level area. Apply the parking brake. Lower the bucket to the ground. Allow the engine to idle. Check the sight gauge that is attached to the hydraulic reservoir. See Figure 3-14. The oil level must be between the upper limit and the lower limit shown on the gauge.
To add hydraulic oil, remove the reservoir breather-cap. See Figure 3-15. FIGURE 3-11 2866 1. Upper Limit 2. Lower Limit FIGURE 3-14 2828 FIGURE 3-12 2826 Check Transmission Oil Level Start the engine and move the machine to a level area. Place the transmission lever in neutral. Apply the parking brake. Allow the engine to idle until engine temperature is between 82°C (180°F) and 93°C (200°F). Remove the transmission dipstick (1, Figure 3-13). Wipe the dipstick clean and then insert it back into the transmission. Remove the dipstick and check the oil level mark. The oil level must be between the low and full marks. To add oil, remove the cap (2) from the transmission oil filler pipe.
FIGURE 3-15 2829 MEGA 300-III Shop Manual INSPECTION, MAINTENANCE AND ADJUSTMENT 3-7