Weekly or Every 50 Operating Hours 8. Place the filter cover into position on the engine. Tighten the bolt to hold the filter cover to the engine. Tighten the drain plug in the filter cover. Perform All Daily Service Checks NOTE Change Engine Oil and Filter Engine oil and filter must be changed after the first 50 hours of operation to comply with the new machine break-in requirements. After the first change, oil and filter should be changed every 250 hours. The engine oil capacity is 21 l (22 qt). The filter holds an additional 1 l (1 qt) of oil. 9. Position the catch container beneath the engine crankcase drain plug. See Figure 3-22.
Remove the drain plug and allow all engine oil to drain out. CAUTION!!! Never attempt to change oil or filter on a hot engine. Hot oil could splash and cause burns. Allow the engine to cool down before changing oil or filter. 1. Position a container to catch the drain oil beneath the engine oil filter. See Figure 3-21. FIGURE 3-22 2836 10. Install the drain plug. Fill the engine with new oil of the type specified in the Table of Recommended Lubricants. Replacing Transmission Oil Filters The transmission oil filter must be changed after the first 50 hours of operation to comply with the new machine break-in requirements. After the first change, the filter must be changed every 500 hours.
FIGURE 3-21 2835 1. Rotate the filter counterclockwise to remove it. 2. Clean the filter head. 2. Remove the drain plug from the bottom of the filter. Allow the oil to drain into the catch container. 3. Grease the filter gasket and the gasket mating surface on the filter head. 3. Remove the bolt from the filter outer cover. Remove the cover, cover O-ring, and filter element. 4. Thread the filter onto the filter head. Tighten the filter 1/2 turn after the filter gasket contacts the filter head. The filter should be torqued to 1.6 to 2.1 kg m (11.5 to 15 ft lb). 4. Discard the filter element. Use a nonflam- mable, non-toxic solvent to clean the inside of the filter cover.
Also clean the cover O-ring. 5. Start the engine and allow it to run until warmed up. Check the filter for leaks while the engine is running. 5. Insert a new filter element into the cover. 6. Insert the bolt through the center of the filter cover. 7. Install the O-ring on the cover. 3-10 INSPECTION, MAINTENANCE AND ADJUSTMENT MEGA 300-III Shop Manual