19. Push the pump drive shaft out the back of the pump. See Figure 4-84. 22. Remove the gear from the adapter housing. See Figure 4-87. FIGURE 4-84 4523 FIGURE 4-87 4527 20. Remove the snap ring from the shaft in the adapter housing. See Figure 4-85. The figure also shows the check ball and spring. 23. Remove the ball bearing from the adapter housing. See Figure 4-88. Also remove the drive shaft and the roller bearing. FIGURE 4-85 4524 FIGURE 4-88 4528 21. Use a press to force the adapter shaft down until it is pressed past the gear. See Figure 4-86. 24. Figure 4-89 contains an exploded view draw- ing of exterior transmission assemblies.
FIGURE 4-86 4525 4-26 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual