15. Remove the hex head screws from the bear- ing cover. See Figure 4-80. Tap the bearing cover and remove it. 17. Remove the bolts that hold the oil pump to the adapter housing. See Figure 4-82. Separate the pump from the adapter housing. The adapter housing contains a check ball and a spring. Be prepared to catch the ball and spring when the housing and pump are separated. FIGURE 4-80 4519 16. Use a puller arrangement to pull the oil pump out of the transmission. See Figure 4-81. Loctite was used to install the oil pump. FIGURE 4-82 4521 18. Remove the spacer ring from the oil pump shaft. See Figure 4-83. Remove the snap ring from the oil pump shaft.
FIGURE 4-81 4520 FIGURE 4-83 4522 Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-25