daewoo — Daewoo Wheel Loader Shop Manual

11. At the back of the bell housing cover, remove the snap ring from the top of the bearing. See Figure 4-76. Remove the bearing. 13. At the back side of the drive plate, remove the bolts that hold the drive plate to the drive shaft. See Figure 4-78. Loctite was used on the bolts when they were installed. FIGURE 4-76 4515 FIGURE 4-78 4517 12. Remove the bolts that hold the drive plate to the torque converter. See Figure 4-77. Loctite was used on the bolts when they were installed. Separate the drive plate and input shaft from the torque converter. 14. Remove the bolts that hold the bell housing to the transmission. See Figure 4-79. Remove the bell housing.

FIGURE 4-77 4516 FIGURE 4-79 4518 4-24 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual