28. Remove the bolts that hold the PTO housing to the transmission. See Figure 4-93. Lift the PTO housing out of the transmission. 31. Match mark the position of the pump mount- ing flange. See Figure 4-96. Remove the bolts that hold the flange in place. Remove the flange. FIGURE 4-93 4532 FIGURE 4-96 4535 29. Remove the snap ring that holds the bearing in place. See Figure 4-94. Remove the bearing. 32. Unbolt and remove the oil tubing. See Figure 4-97. FIGURE 4-94 4533 FIGURE 4-97 4536 30. Hold open the snap ring on the opposite side of the shaft. See Figure 4-95. Use a large plastic hammer to drive the hollow drive shaft out of the PTO housing. 33. Match mark the position of the bracket.
See Figure 4-98. Remove the bolts that hold the bracket in place. Remove the bracket. FIGURE 4-98 4537 FIGURE 4-95 4534 4-30 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual