5. Remove the KR spur gear with the bearing and washer. See Figure 4-119. FIGURE 4-121 4560 FIGURE 4-119 4558 The type “B” reverse gear is held in place with a bolt. Remove the bolt that retains the reverse gear. See Figure 4-122. Remove the washer and reverse gear. 6. Remove the snap ring and then remove the discs from the clutch pack. See Figure 4-120. FIGURE 4-122 4561 FIGURE 4-120 4559 7. Follow Steps 6, 7, and 8 in the KV/K1 disassembly procedure to remove the snap ring, piston, and needle bearing. See Figures 4-112, 4-113, and 4-114. 9. Remove the bolts and then remove the shaft. See Figure 4-123. Remove the spur gear from the transmission. 8.
The type “A” reverse gear is held in place with a snap ring. Remove the snap ring that retains the reverse gear. See Figure 4-121. Remove the reverse gear. FIGURE 4-123 4562 4-36 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual