Transmission Assembly 3. Install the snap ring into the bottom of the out- put shaft bore in the transmission housing. Install the shim washer on top of the snap ring. Shim washer thickness must equal 0.5 mm. Install the inner bearing on top of the spacer. Brake Drum 1. Steps 1 and 2 are only necessary for units equipped with a brake drum. Install an O-ring into the groove of the anchor pin. See Figure 4-149. Coat the O-ring with grease. Install the anchor pin into the bore in the transmission. Coat the installation bolts with Loctite. Install the bolts to hold the anchor pin in place. 4. Place the oil baffle plate over the housing bore, on top of the bearing inner race.
FIGURE 4-151 4589 FIGURE 4-149 4587 See Figure 4-151. 5. Set the gear on the inner bearing. See 2. Assemble the brake cam onto the second anchor pin. See Figure 4-150. Install the O-ring into the groove on the anchor pin. Coat the O-ring with grease. Coat the installation bolts with Loctite. Install the bolts to hold the anchor pin in place. FIGURE 4-152 4590 Figure 4-152. Align the marks on the bearing and the gear. FIGURE 4-150 4588 4-42 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual