daewoo — Daewoo Wheel Loader Shop Manual

2. Use a depth micrometer to measure from the top of the bore, to the edge of the bearing on the output shaft. See Figure 4-155. In the example shown, the distance was measured FIGURE 4-153 4591 6. Install the snap ring. See Figure 4-153. FIGURE 4-155 4593 End Plate Selection 1. Place the spacer and the speedometer worm at 79.55 mm (3.131"). This is measurement A. 3. Install a snap ring on top of the bearing. Use a depth micrometer to measure from the top of the bore to the edge of the snap ring. See Figure 4-156. In the example shown, the dis- FIGURE 4-154 4592 gear on the output shaft. See Figure 4-154. Heat the parts if necessary. Set the output shaft into the transmission.

FIGURE 4-156 4594 NOTE tance was measured at 79.20 mm (3.118"). This is measurement B. The following steps describe taking measurements and using the measurements to calculate a shim thickness. The measurements shown in these steps are an example only. Be sure to take your own measurements and perform your own calcula- tion to derive the correct shim thickness for your machine. Subtract measurement B from measurement A. 79.55 mm -79.20 mm 0.35 mm The difference between the two measure- ments must be in the range of .30 – .50 mm (.0018 – .0196"). If the difference is not within this range, change the thickness of the shim washer beneath the inner bearing.

Mega 300-III Shop Manual TORQUE CONVERTER AND TRANSMISSION 4-43