4. Install the outer bearing over the output shaft and into the bore. Install the snap ring into its groove above the bearing. Use a feeler gauge to measure the gap between the top of the bearing and the bottom of the snap ring. See Figure 4-157. The gap that was measured in 6. Install the shaft seal into the output shaft bore. See Figure 4-159. Use a bearing driver to force the seal down until it bottoms on the FIGURE 4-159 4597 FIGURE 4-157 4595 snap ring. 7. Apply Loctite to the bolts that hold the semicir- cular oil baffle plate in place. Install the baffle plate and use the bolts to hold the plate in this example was 1.80 mm (.0708"). 5. Remove the snap ring.
On top of the bearing, install a shim washer that is equal to the FIGURE 4-160 4598 FIGURE 4-158 4596 place. See Figure 4-160. Tighten the bolts to 49 Nm (36 ft lb). gap measured with the feeler gauge. See Figure 4-158. Install the snap ring. FIGURE 4-161 4599 4-44 TORQUE CONVERTER AND TRANSMISSION Mega 300-III Shop Manual