Komatsu — 16.3 OTHER TROUBLE

16.

TROUBLESHOOTING 16.3.3 ENGINE Problem Main Cause Remedy + Engine oil pan oil level is low + Add oil to specified level, see 24.3 EVERY 10 HOURS SERVICE + Replace element, see 24.6 EVERY 250 HOURS SERVICE + (Replace light) Engine oil pressure warning light re- mains lit when engine speed is raised after completion of warm up + Clogged oil filter element + Defective warning light Cooling water level low, water leak- Add cooling water, see 24.3 EVERY 10 HOURS SERVICE Adjust fan belt tension, see 24.11 WHEN REQUIRED Steam is emitted from top part of radia- tor age Loose fan belt Dirt or scale accumulated in cooling system Change cooling water, clean inside of system, see 24.9 EVERY 2000 HOURS SERVICE Clean or repair, see 24.7 EVERY 500 HOURS SERVICE (Replace thermostat) Tighten cap or replace Clogged radiator fins or damaged fins Indicator of water temperature gauge is out of run range Defective thermostat Loose radiator filler cap (high altitude operation Defective water temperature gauge (Replace water temperature gauge) Lack of fuel Add fuel, see 24.3 EVERY 10 HOURS SERVICE Repair place where is sucked in Air in fuel system Defective fuel injection pump or noz- zle Starting motor cranks engine slug- gishly Defective compression 0 Defective valve clearance Engine does not start when starting motor is engaged (Replace pump or nozzle) See 16.3.1 ELECTRICAL SYSTEM 0 (Adjust valve clearance) + Too much oil in oil pan + Add oil to specified level, see 24.3 EVERY 10 HOURS SERVICE + Change to specified fuel Exhaust smoke is white or blue + Improper fuel + Clogged air cleaner element + Clean or replace, see 24.10 PERI- ODIC + (Replace nozzle) + (Adjust valve clearance) Exhaust smoke occasionally turns black + Defective nozzle + Defective compression Combustion noise occasionally makes breathing sound + Defective nozzle + (Replace nozzle) + Low grade fuel being used + Overheating + Damage inside muffler + Excessive valve clearance Abnormal noise generated (combustion or mechanical) 2-67