Komatsu — 16.3 OTHER TROUBLE

16. TROUBLESHOOTING 16.3 OTHER TROUBLE ( ): Always contact your Komatsu distributor when handling these items. + In cases of abnormalities or causes which are not listed below, please contact your distributor for repairs. 16.3.1 ELECTRICAL SYSTEM Problem Main Cause Remedy + Defective wiring Voltmeter does not register charge when engine runs at high idle + (Check, repair loose terminals, dis- connections) + Defective adjustment of fan belt ten- Voltmeter flickers while engine is run- sion ning + Adjust fan belt tension.

For details, see 24.11 WHEN REQUIRED Voltmeter registers extreme high charge + Defective alternator + Defective wiring + (Replace) + (Check, repair) Abnormal noise is generated from alter- nator + Defective alternator + (Replace) Starting motor does not turn when key + Defective wiring switch is turned to START + lnsufticient battery charge + (Check, repair) + Charge Pinion of starting motor keeps going in + Insufficient battery charge and out + Charge Starting motor turns engine sluggishly + Insufficient battery charge + Charge + Defective starting motor + (Replace) Starting motor disengages before en- + Defective wiring gine starts + Insufficient battery charge + (Check, repair) + Charge 16.3.2 CHASSIS Problem Main Cause Remedy When transmission/steering lever is moved to desired position, machine does not start or traveling speed is slow ) Oil pressure of drive train is not raised 1.

Insufficient oil in drive train sys- tem 2. Clogged strainer in transmission case + Add oil to specified level, see 24.4 EVERY 50 HOURS SERVICE + Clean strainer When transmission/steering lever is moved to turn machine, machine does not turn and goes straight + Steering clutch of moved side is not disengaged + Brake of moved side is not actuated + Adjust brake. When brake pedal is depressed, ma- chine does not stop + Brakes out of adjustment + Adjust brake.

Track comes off + Track too loose + Adjust track tension, see 24.11 WHEN REQUIRED Abnormal wear of sprocket + Track too loose or too tight Blade rises slowly, does not rise + Lack of hydraulic oil + Add oil to specified level, see 24.3 EVERY IO HOURS SERVICE 2-66