21. STANDARD TIGHTENING TORQUES 21.2.1 GRADE 5 AND 8 NON-PHOSPHATE COATED HARDWARE Recommended torque for all Standard Application Nuts and Bolts, provided; all thread surfaces are clean and lubricated with SAE-30 engine oil or joints are rigid, that is, no gaskets or compressible materials are used. When reusing nuts or bolts, use minimum torque values.
THREAD GRADE 5 N*m Ibffi I I 1/4NC 8 6 9/16NC 1 114 I 84 3/4NC 1 278 I 205 3/4NF 312 240 7/8NC 414 305 7/8NF 1 454 I 334 I-1/8NF 1 929 I 685 I-1/4NC 1166 860 I-1/4NF 1295 955 I-3/4NC 3213 2370 I-1/2NF 2291 1690 2NC I 4813 I 3550 Multiply the standard torque by 0.65 when finished jam nuts are used, 0.7 when Molykote, white lead or similar mixture are used as lubricants, 0.75 when parkerized bolts or nuts are used, 0.85 when cadmium plated bolts or nuts and zinc bolts w/waxed zinc nuts are used or 0.9 when hardened surfaces are used under the nut or bolt head. The General Torque must be used in all cases where SPECIAL TORQUES are not given.
Values listed in this manual are lubricated (wet) threads; values should be increased l/3 for non-lubricated (dry) threads. 3-l 6