21. STANDARD TIGHTENING TORQUES 21.2.2 GRADE 8 PHOSPHATE COATED HARD- WARE This chart provides tightening torque for general purpose applications using original equipment standard hardware as listed in the Parts Books for the machine involved. NOMINAL THREAD STANDARD TORQUE f 10% Narn Ibfft DO NOT SUBSTITUTE. II4 I IO 1 8 Original equipment standard hardware is defined as Grade 8, coarse thread bolts and nuts and thru hardened flat washers (Rockwell “c” 38-45) all phosphate coated and assembled without supplemental lubrication (as received) condition.
The torques shown also apply to the following; 9/16 1 130 I 100 314 I 325 I 240 518 I 180 I 140 Phosphate coated bolts used in tapped holes in steel or gray iron. Phosphate coated bolts used with phos- phate coated prevailing torque nuts (nuts with distorted threads or plastic inserts). Phosphate coated bolts used with copper plated weld nuts. 718 I 520 I 390 1 I 780 I 580 I-118 1110 820 Markings on bolt heads or nuts indicate material grade ONLY and are NOT to be used to determine required torque.
l-1/4 1565 1160 I-318 2050 1520 I-112 2720 2020 I-314 3380 2510 2 5080 3780 21.2.3 STANDARD METRIC FASTENERS II NOMINAL STANDARD TORQUE THREAD f 10% II This chart provides tightening torque for general purpose applications using original standard hardware as listed in the Parts Book for the machine involved. II MILLIMETERS I N*m I Ibf fi II II M6 I IO I 7 II DO NOT SUBSTITUTE. II M7 I 16 I 12 II II M8 I 23 17 II II Ml0 I 34 II Original standard hardware is defined as metric class 10.9 bolts and class 10.0 nuts and thru flat washers (Rockwell “C” 38-45) all phosphate coated and assem- bled without supplemental lubrication.
Ml2 80 60 Ml4 125 90 The torques shown also apply to the following; Ml6 200 150 Phosphate bolts used in tapped holes in steel or gray iron, with phosphate coated prevailing torque nuts or with copper plated weld nuts. M20 385 290 II M22 1 530 I 390 II II M24 I 670 I 500 II II M27 I 980 I 730 II Ml8 275 200 Markings on bolt heads or nuts indicate material class ONLY and are NOT to be used to determine required torque. M30 1330 990 M33 1790 1330 M36 2325 1730 M39 3010 2240 3-17